Inconsistent adhesion usually points to a breakdown in cleaning, coating, or process control. Here’s what to look for:
- Clean thoroughly. Oils, stamping lubes, or corrosion inhibitors left on the surface can block pretreatment from bonding. Make sure your cleaner is built for your soil load, and that your rinse stages aren’t just moving contaminants downstream.
- Evaluate your pretreatment chemistry. Zirconium and phosphate coatings both rely on tight control of pH, temperature, and dwell time. If you’re outside the recommended range, even slightly, you can end up with undercoating or uneven film build.
- Check for substrate mismatch. Some chemistries behave differently on cold-rolled steel, aluminum, and Galvanneal. If you’re running mixed metals without the right formulation, one of them may be under-reacting.
- Look at line timing and part handling. Short dwell times, long dry-off periods, or dirty gloves during handling can all cause adhesion issues, even if your chemistry is spot on.
Adhesion issues aren’t random. They’re traceable. Surface prep, chemistry, handling… it all leaves a trail.
Follow it, and you should find the fix.